runrandlsq Documentation
Isis 2 Documentation
runrandlsq Documentation
runrandlsq.pl - Runs randlsq, the geodetic solver. This program runs randlsq to perform a geodetic solution. The program is intended to be run after running pix2mm.pl and genapdat.pl. PROGRAMMER: Ben Atkin
| Parm | Description | Default |
|---|---|---|
| INPFILE | Input file | NONE |
| MMFILE | Millimeter measurements | NONE |
| OUTFILE | Output file | NONE |
| PVLFILE | Parameter file | NONE |
| GPTFILE | Ground point file | -- |
| DTMFILE | DTM Cube file |
ADDITIONAL NOTES:
| Parm | Description |
|---|---|
| INPFILE | The input data file (from previous solution(s), genapdat.pl, or a combination of the two). |
| MMFILE | A rand millimeter measurement file (from pix2mm.pl). |
| OUTFILE | Output file. This will be in the same format as the input file, but have updated values for the points. |
| PVLFILE | The parameter file, in PVL. See test directory for examples. |
| GPTFILE | A ground point file. This file contains more information about ground points than INPFILE. |
| DTMFILE | An optional ISIS level 2 cube file, where each DN value represents the local radius for the point at that location. This file is used to compute the radius of the planet/body at the corresponding match point location. |
Contact us online at the Isis Support Center: http://isisdist.wr.usgs.gov